neveroddoreven
About
- Username
- neveroddoreven
- Joined
- Visits
- 27
- Last Active
- Roles
- Member
Comments
-
Thanks Repetier for looking into this. As an aside, I intend to stick with Repetier Firmware in my 4 watt blue diode laser cutting endeavors, using the new LaserWeb open source project. Those folks are strongly preferring Smoothieware due to varia…
-
I would also benefit from having the option of dual X endstops, as I just built a 1500mm^2 laser cutter with dual X motors to keep things perpendicular.
-
Yes, the RioRand RRD fan extender works fine on my RAMPS 1.4 board. The RRD extender has a connector that covers up all four rows of pins for D11, D6, D5, D4. But it only has support for two fan extenders. I plugged it so that it only covers D5 a…
-
I increased the Z multiplier to 4, so that one encoder click advances 0.01mm. This made it easier to adjust the Z babystep, but I still see the 0.92.4 firmware hang if I turn it two or three clicks while an arc is being printed. It reproduces rath…
-
One more thing - I read elsewhere from another person upgrading to a conventional dual extruder (two separate hotends) that they had some weird problems that went away after disabling EEPROM usage -- so I had also tried disabling EEPROM to no avail.