rapturedbyrobots
About
- Username
- rapturedbyrobots
- Joined
- Visits
- 8
- Last Active
- Roles
- Member
Comments
-
Nope. Reading is steady when not heating. Just unable to heat up when near the print bed. Layer fan is disconnected to avoid additional cooling during testing. So there is really no visible reason it should be faulty when it drops. Perhaps a ba…
-
Quick question. I was under the impression PID was heat manager 1 (not 2), with bang bang being 0 and dead time being 3. Is that correct?
-
Will try heat manager 2. Strange heating behavior only manifests when effector is within 50 cm of the print bed. Think that's related to the heat manger somehow?
-
OK...turned off decoupling test in Extruder.cpp. Now I'm getting crazy temperature fluctuations over a 20°C range. Is there anyway to go back to the trusty old PID tuning of v0.91? This new release is a huge PITA.