RobertoReis

Comments

• I have a similar problem. The LCD show 32 on buffer - Smartramps + AZSMZ Mini display 12864 and repetier .91 + arduino Due , the moves start and first move ok.. before next layer, a pause with one or 2 seconds, second layer runs... and again... if a…

  in Strange Radds behaviour Comment by RobertoReis July 2016
• Same problem... probe is craze... Here.. it run the command G32 S2, but when finish, the bed goes up and down when move X and Y and the Z runs very high... as 20mm to 0 or more

  in Z-Probe height problems after upgrading to 0.92.8 Comment by RobertoReis June 2016
• I believe that a tower as a reference to be chosen by the user and accuracy in time to give the command,  it can be a starting point. For example. My endstop Z is fixed because I spend all supply wires to plate lamp sensors and hotend the tower Z an…

  in Delta printer Auto Calibration Comment by RobertoReis November 2015
• Just a correction. The Marlin support the Cyplops hotend. Look for a Marlin Mago Kimbra. There are a lot of options. But i preffer the Repetier firmware too... q=)

  in Z-homing no endstop hit Comment by RobertoReis July 2015
• Anyone here can help me to configure this LCD with arduino due and smart ramps board? Thanks

  in Repetier configuration tool and Full Graphic Smart Controller Comment by RobertoReis July 2015