› ›

unltd108

About

Username
unltd108
Joined
Visits
12
Last Active
Roles
Member

Comments

  • OK,  I finally found another post that told to go to Printer Settings  / Script tab...    And, I sort of see why only some buttons/commands now work.   I don't know if this is considered a FIX or more proper,  or whatever,  or if it is a Bug in the …
    in Editing G-code script for manual control buttons. Comment by unltd108 August 2015
  • same problem,  no one has posted a reply to CalData?   After upgrading the script drop down box is not there,  no way to edit scripts.   Previously i had scripts for buttons 1-4    for my Delta printer, i would send head to 3 areas around the round …
    in Editing G-code script for manual control buttons. Comment by unltd108 August 2015
  • It seemed to be going good using the Server,  until I plugged in my cell phone to charge,  when i unplugged it, again the Communication with the printer stopped.   It didn't just pause, it broke.  The print was a loss, but, i tried unplugging the us…
    in Printing gets slow and choppy after several prints Comment by unltd108 July 2015
  • Ok, I will look into seeing how to use the server.  If the Host is to communicate with the Server then the Host should see that the Server is already connected and instead of showing the Red Connect button, it should be - maybe Blue - showing that t…
    in Printing gets slow and choppy after several prints Comment by unltd108 July 2015
  • Actually, the Server connects with the printer, I can control it from the server control panel.  But, when the server is connected the Repetier Host won't connect with the printer, so i can't do any printing until i deactivate the printer from the s…
    in Printing gets slow and choppy after several prints Comment by unltd108 July 2015
  • Well, so far so good.  It's zooming past the point where it choked before.   But, after installing 1.5.1 I wasn't able to connect to the printer. I rebooted.  But, i've never used the Server before, not sure how that is to be set up.  I downloaded 1…
    in Printing gets slow and choppy after several prints Comment by unltd108 July 2015
  • rest of post< 23:27:04.181 : N131078 M117 ETE 1h 32m 09s *35 < 23:27:04.181 : N131079 M105 *58 < 23:27:04.181 : N131080 G1 X12.369 Y54.763 E20.5685 *121 < 23:27:04.181 : N131081 G1 X11.669 Y54.575 E20.59648 *67 < 23:27:04.181 : N13108…
    in Printing gets slow and choppy after several prints Comment by unltd108 July 2015
  • I ran with just the orig - no copy,  it went to layer 12 and choked.   I had looked at the PRINTER - JOB STATUS    when it choked previously and it was on line 1297xx at layer 8 And I ckd job status with no copy    and again it was at line 129700   …
    in Printing gets slow and choppy after several prints Comment by unltd108 July 2015
  • I'm getting same problem.  But, I just upgraded to 1.5.0 and this is my first print using since upgrading.  I ran print twice, and it gives problem in exact same Layer and same location.   It will print fine until it hits the spot, then it takes a s…
    in Printing gets slow and choppy after several prints Comment by unltd108 July 2015