remeslennik
About
- Username
- remeslennik
- Joined
- Visits
- 10
- Last Active
- Roles
- Member
Comments
-
Communication does not happen and there is no information about the printer. Speed is correct. Reset when you connect to your program was the default as well as in where the program works correctly. I tried other settings but to no avail.
-
Today I noticed that the LEDs still lit, but very dimly. These boards may use different resistance in the firmware have to be able to select the desired value.
-
On the first question is not clear. The hot end includes. With some firmware immediately begins to warm up with the other not, but somehow included. He never shuts posde inclusion in this problem. I changed my card and the printer works. But LEDs ar…
-
Do I understand that you have to offer on board thermistor disconnect the hot end, and in this case it should not be heated in any way, and if it is warm, then the problem is a fault in the board.
-
Temperature for printing pla me want 190 degrees, hot end heats without stopping above $ 190 and I turn off the power at a temperature of 240 degrees, one in the line display temperature of the hot end of the figure was more than 400. I decided tha…