› ›

MBasaraba

About

Username
MBasaraba
Joined
Visits
8
Last Active
Roles
Member

Comments

  • That was it thank you so much. I am using the web configuration tool. I know when I made my last firmware for the Azteeg X3 board about a year ago there was a spot to select the information about the heatbed but I am not finding that now when runni…
    in Firmware will not change Steps/MM Comment by MBasaraba January 2017
  • I think the issue was I was trying to wire up all 3 wires.
    in Machine End Stops Comment by MBasaraba November 2014
  • Well I got my printer to "Work". My MB can regulate the heat of 3 extruders. Say I wanted to turn them all on at the same time, but not list it as more than one extruder when I slice, can I use the "custom G-Code" tab to add a command to turn all …
    in Repetier will not connect Comment by MBasaraba September 2014
  • I found an old backup I had the previous version,1.06, of PiBot saved on and loaded it, got the motors to move again but the hot ends will not heat. The thermistor shows proper temperature and it says "Heating Extruder" but it doesnt. I will have to…
    in Repetier will not connect Comment by MBasaraba September 2014