Lab2

About

Username
Lab2
Joined
Visits
31
Last Active
Roles
Member

Comments

  • The holes are not really printed as circles, but a polygon inscribed within the circle.  This will always give a smaller opening than the circle.
  • Thanks.  Why does a simple cube have 12 faces rather than 6?
    in Cut Objects Comment by Lab2 June 2015
  • The reason it was too large is because the dimensions in the file were in millimeters. I had later read a file in inches, and forgot to change back before loading this one. Thanks for your comments. I learned a few new things.
    in Cut Objects Comment by Lab2 June 2015
  • Found my problem. It thought my object was too large, when I did a scale to maximum, it reduced the size and now behaves after cutting. Is there a way to determine the dimensions of an object?
    in Cut Objects Comment by Lab2 June 2015
  • When I am seeing the "Cut Object" parameters, clicking the X hides the parameters, but leaves the view of the object still cut. How do I get back to viewing the full, uncut object?
    in Cut Objects Comment by Lab2 June 2015
  • OK. setting G-code flavor to "no extrusion" will create the result I was seeing. Thanks
  • Thank you for your reply Yes, there was nearly 130000 lines of g-code loaded and toggling show/hide filament made no difference. Fixed the problem by going to configuration (for Slic3r) from slicer tab   on Printer Settings tab changed from My Sett…
  • It works fine with CuraEngine, but not Slic3r even though it did once.