petertn

About

Username
petertn
Joined
Visits
4
Last Active
Roles
Member

Comments

  • How it is with palete? I mean 3 and 3pro, not in accessory mode, but comunicating with palette
  • ok, tnx. But if you are able check pls fluid web interface ... it is possible to make there butons, scripts butons ... 
    in Klipper Comment by petertn August 17
  • my fault, adxl was not working, using the old one used solved this problem
  • I am playing with ... but see my another posts
  • printer shows Invalid adxl345 id (got 0 vs E5)
  • And it is not working --2022-08-16 07:38:23--  http://download1.repetier.com/files/server/extras/inputShaping.shResolving download1.repetier.com (download1.repetier.com)... 94.130.164.39Connecting to download1.repetier.com (download1.repetier.com)|…
  • it is working now, but I don't know why ... but pid calibration ... it is working, data are stored et the end of config, default config on extruder or bed are automatic commented from klipper and then starts problems, it is necessary to cut it from …
    in Klipper Comment by petertn August 15
  • # This is the default configuration for the printer: Voron350R1# This option is needed if you want to use the recover feature so that Repetier-Server can manually set the z position in Klipper[force_move]enable_force_move: true # This file contains …
    in Klipper Comment by petertn August 15
  • uploadet firware using R-S, still not working. Connected to old paspi with pure clipper and it is working without problems. I do not understand it ...
    in Klipper Comment by petertn August 15
  • Repetier said: > And now MCU Protocol error ..  Make sure to compile a new printer firmware from the installed sources. Version mismatch might cause this. Version is the one you installed 0.10 or latest master which is constantly changing…
    in Klipper Comment by petertn August 15
  • restart_method: command is not working too, what is the right command?
    in Klipper Comment by petertn August 15
  • And now MCU Protocol error .. I am tired ....
    in Klipper Comment by petertn August 15
  • sensor_type: Generic 3950 to sensor_type: NTC 100K beta 3950
    in Klipper Comment by petertn August 15
  • tnx, amazing support. The best spent 50 euros ;-)
  • Tnx, I was trying it :-))) If I use another port?Where are located licencie data? It is possible only copy it to fresh instal? My server is death and I am not able to deactivate the license... sorry for this
  • According your answer the best solution is to install server on both raspis and use monitor. A am using kiauh to instal klipper and fluid web server. It is possible only instal server on this running configs? Because I want to use fluid as a gui too…