› ›

MikeB

About

Username
MikeB
Joined
Visits
44
Last Active
Roles
Member

Comments

  • It could be very usefull to calibrate a Delta printer, to have a command (G30 D? for Delta) that will do a Z probe on the various :0,00, bed_radius-SIN_60 * bed_radius, COS_60 * bed_radius-SIN_60 * bed_radius, -COS_60 * bed_radius0.0, -bed_radiusSIN…
    in Delta printer Auto Calibration Comment by MikeB July 2015
  • The last u8glib library I can find is the V1.17 dated December 2014. Do you have another library?
    in Extruder motor stop working during print Comment by MikeB July 2015
  • I tried this with a Kossel Delta and it arrived at a good result :https://github.com/RichCattell/MarlinWith my big delta I still have a problem of not plain movement.I'll try to follow your suggestion.Thanks
    in Delta printer Auto Calibration Comment by MikeB July 2015
  • Yes . I have the graphic display.Just for your information, I checked with Baudrate at 115200 and at 250000. In both cases I had random errors.The strange thing is that I have the error with both repetier firmware (most frequent) and with Marin firm…
    in Extruder motor stop working during print Comment by MikeB June 2015
  • I discovered that the problem is Repetier Host.I tested with marlin firmware and also with Repetier firmware. During the Printing process I start having these errors :Error:checksum mismatch, Last Line ....If I print the same GCODE form the SD card …
    in Extruder motor stop working during print Comment by MikeB June 2015
  • I'll wait for a new controller, SainSmart 2 in 1 to make a further test. Also I notice that with the actual RAMPS + Arduino 2560, with Marlin I don't have any problem to use it at 250000 bps, with Repetier I have to use it at 115200 bps. About the d…
    in Extruder motor stop working during print Comment by MikeB June 2015