› ›

nflawson

About

Username
nflawson
Joined
Visits
10
Last Active
Roles
Member

Comments

  • Thank you, are these conditions active even in manual mode from the Repetier-host?I have checked anyway and I meet the conditions you suggest but still no go. If I manually push the PLA into the extruder I see a thread (o.3mm) of plastic exiting but…
    in Extruder motor won't go Comment by nflawson September 2014
  • Here's my config I couldn't fit it in the original post...#define DRIVE_SYSTEM 0 #define XAXIS_STEPS_PER_MM 100 #define YAXIS_STEPS_PER_MM 100 #define ZAXIS_STEPS_PER_MM 407 #define EXTRUDER_FAN_COOL_TEMP 50 #define EXT0_X_OFFSET 0 #define EXT0_Y_OF…
    in Extruder motor won't go Comment by nflawson September 2014