› ›

minhhienbk

About

Username
minhhienbk
Joined
Visits
9
Last Active
Roles
Member

Comments

  • I watched on youtube. The sensor seem to be used for endstop and probe.
    in Z probe does't measure using G32 Comment by minhhienbk June 2015
  • I added Zmax endstop in my machine so the probe works for bed-autoleveling now. However, it takes time for every measured point, because the bed go down until touch the Z endstop then go up for measurement.  I don't know if you have another solution…
    in Z probe does't measure using G32 Comment by minhhienbk June 2015
  • It means that we should use a Zmax endstop for homing before probe. I'll try to add a Zmax endstop and let you know the result. Thank you very much for your help.
    in Z probe does't measure using G32 Comment by minhhienbk June 2015
  • You're right, my sensor works with 10-30v so I used the voltage diviser to obtain 5v before connect to Z pin on Ramps 1.4. Therefore, it works correctly when I send G28.  In my machine, I connect the sensor to Z_min pin on Ramps (I haven't mechanica…
    in Z probe does't measure using G32 Comment by minhhienbk June 2015
  • Thank you for your reply. I have tested G31, for all cases (triggered/not triggered) are always H. How can I fix this problem, please? and Could you please tell me how I can change frequency of switching to 200Hz?I appreciate for your help.
    in Z probe does't measure using G32 Comment by minhhienbk June 2015
  • Dear All, Could you please kindly help me to solve a problem with Z-probe (auto leveling)? I build a H-bot printer (X, Y on the top of machine; the bed moves from top to bottom so Z probe is located at min) with Z probe (Inductive Proximity Sensor A…
    in Is there a complete step by step manual for building Z probe Comment by minhhienbk June 2015