raykholo
About
- Username
- raykholo
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Yes, of course. We actually got it working by defining the Azteeg X3 Pro Controller (5 extruder capability) and changing all the pins to the Ramps and Expansions setup. Extruder Motors 3 and 4 are spinning, and I have to get everything else like th…
-
Same problem as always when trying safe solution in configuration.h With 2 extruders setup, expansion board works when defined as E0 but not as E1. I tired defining both sets of pins we use for motors 3 and 4 and all work when set up as E0 but n…
-
Sure, I tried this but same results as before. I commented out the pin definitions from my last post in configuration.h and put them in with ...motherboard == 33... section of pins.h. Same behavior as always. Then I also changed the definitions o…