jmjcoke
About
- Username
- jmjcoke
- Joined
- Visits
- 16
- Last Active
- Roles
- Member
Comments
-
I found the problem, in temptable_13 there is one number (11211 that should be 1211).
-
I just tested and the results changed but did not work correctly, went to 80c and then the feedback slowed down to a crawl moved .1c every 3 seconds.
-
Ok, I will ASAP. (November 5th) Can you post the section of code you changed?
-
I am using an Azteeg X3 Pro and I am using A3 as the analog intput which is a standard analog pin, and giving the card from E3D 5V and GND. when I select E3D PT100 the temp starts at the correct temp (20ishC) but when you turn on the heater the feed…
-
ok, I got it working, I have a Azteeg X3 Pro with SD8825 stepper drives installed on a rigidbot frame. I had 1/32 micro selected for all axis, I had to set z axis and both extruders to 1/16 micro. then I could change steps in them, before changing I…
-
I have the same problem with z axis, no matter what I put in as steps per mm in z axis movement distance never changes, yes I have made other changes that have worked, so the eeprom is enabled.