galmiklos
About
- Username
- galmiklos
- Joined
- Visits
- 7
- Last Active
- Roles
- Member
Comments
-
Thank you, it was "@isathome" I was looking for, apparently. I eventually found the page in the documentation describing the "host commands" (at the bottom of https://www.repetier.com/documentation/repetier-host/gcode-editor/), I am just wondering i…
-
I use CamBam, and yes, I can configure the G0 move to something like "G0 F2000", but CamBam would not add an F to its G1 moves, so all subsequent G1's would run at max speed. In Repetier firmware, the last feedrate is always stored in "Printer::feed…