P_O
About
- Username
- P_O
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Hello again ! Well, this was it This tiny bit of gcode did it, and everything is now behaving as expected. Much thanks ! Going back to some of the earlier points : I do understand that CuraEngine is quite barebones and limited compared to all the …
-
Might aswell share the problematic Gcode. Here is the beginning of what I am getting, with "Enable Retraction" turned off in the CuraEngine settings : ;LAYER:0M107;LAYER:1M106 S63G0 F3840 X16.196 Y41.247 Z0.310;TYPE:WALL-INNERG1 F960 X16.578 Y41.11…
-
Hello and thank you for another answer to my barrage of questions. I think I am just used to leveling as high as possible, therefore used to getting that satisfying "squished" first layer and skirt as mentioned. But I should have probably mentioned…
-
Hello ! Thank you for your replies. I should have mentioned that I am actually perfectly fine with my current print settings as generated by the ancient CuraEngine. I am used to recent/regular Cura slicing with modern machines (Ultimaker, Creality …
-
3 - And also, I do not understand the following help hint : What does this actually mean ? Since Gcode is just a set of instructions for the motors, and since the printer itself is completely blind, the machine has no way of knowing that it may be…
-
[Sorry, too late for editing. One hour is too short IMHO.] - - - - Is this trying to say "Speed of filament extrusion when operated from the Manual Control tab" ?
-
Hello ! First of all thank you for such a quick answer, that's appreciated. I would say that even though it involves some advanced technical knowledge, your explanation of the process has the merit of being much more clear and definitive than the …