MiniDrum

Comments

• Only on the x-axis, 10cm detail plus 3mm, on the y-axis the game is unchanged.Thanks for the advice, I'll try to check the geometry carefully.

  in size is incorrect on the x-axis Comment by MiniDrum May 2023
• I found where it changes in the #define ZHOME_HEAT_HEIGHT parameter, thanks

  in dev2: Leveling and Bump Correction Question Comment by MiniDrum April 2022
• Repetier said: Except grid size (only in configuration.h) you can change z probe settings in eeprom editor in our server for example. When entering G33, the height is again 20 mm (In the journal: Reference Z for measurement:20.000)(

  in dev2: Leveling and Bump Correction Question Comment by MiniDrum April 2022
• Repetier said: Thanks for the insight. 25 minutes is in deed a long time.You might reduce it considerably if you reduce min bed height. When you do it regularly 2mm might be enough and time comes linear with that value more or less. Good a…

  in dev2: Leveling and Bump Correction Question Comment by MiniDrum April 2022