rlyt123456

Comments

• Finally, I figure out problem where is.My carriage width not equal effector width.My carbon stick width in carriage side bigger then carbon stick width  in effector  side. Thank you very much.

  in print object size bigger then 3d model object size Comment by rlyt123456 December 2015
• Thank you for getting back to me. Oh, I always only calibrate diagonal length/radius, I will try check steps. When I calibrate diagonal length/radius, I measure  diagonal rod length and fill it to eeprom.then measure  diagonal radius fill it , Next…

  in print object size bigger then 3d model object size Comment by rlyt123456 May 2015