k_neo
About
- Username
- k_neo
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Thank you. I did uncheck the SD support in firmware config tool. Looks like it does not change anything. Still reports SD issues. Flashed, connected and sent M502 then M500. At the very least I am getting a hang on configuring my table as I want it…
-
No card inserted at and I am mainly using this 3d printer with the usb cable. The message about SD card is displayed on connect/reset. I am learning 3d printing and havent used the sd card at all. About the SD card suport, its mainly in "Features"…
-
Would you mind telling me the slicer you are reffering to? I dont see those options in slic3r
-
Here is what I am trying to do with 3d printing. I have a vector graphic file, just lines. I want to print these vector lines/splines as they are with a single pass of the extruder. What I have done so far is sweep triangular profile on all of …
-
Thank you. I have been trying both versions while I try to make sense of the workflow and all. Very new to this but have a router with mach3. Thing is that I am trying to maximize the printing area for a project I have and I have found that if I se…