frarce

Comments

• another question, everybody told me that chance the firmware to marlin, they said that marlin is better firmware, I got a marlin firmware fot k280, but I am scare about it, Is repetier compatible with marlin firmware? are you agree with this change?…

  in extruder is not increasing the distance according to the height of each layer Comment by frarce May 2022
• thanks, it's a phisical contact between tester and nozzle block trough a thermocouple, and the difference between tester and firmware measure  is 50 C plus Great sugestion up the temp at tester shows 200 C, same with the bed, but in the nozzle I ca…

  in extruder is not increasing the distance according to the height of each layer Comment by frarce May 2022
• EEprom bed settings: Bed Preheat Temp: 60 C Bed Heat Manager: 1 Bed PID drive max: 255 Bed PID drive min: 20 Bed PID P-gain: 98 Bed PID I-gain: 16.5 Bed PID D-gain: 145 Bed PID max value: 255 EEprom extruder settings: Bed Preheat Temp: 255 C Bed He…

  in extruder is not increasing the distance according to the height of each layer Comment by frarce May 2022
• Hello, please excuse my absence, I was on a mission in the jungle of Costa Rica for almost 3 months, yesterday I returned home and I want to resume the pending configuration for the k280, I did some printing tests and it continues to clog the nozzle…

  in extruder is not increasing the distance according to the height of each layer Comment by frarce May 2022
• you're a genius, thanks to all your help I am 98% done, ! did the calibration of the extruder, when I mark 10cm in the filament and run G1 E100 F100 the extruder avance 10cm exactry and now the printed looks great at 0.2 layer, I did the 2cm cube wi…

  in extruder is not increasing the distance according to the height of each layer Comment by frarce February 2022
• trying to follow the calibration guide that you send me, Pronterface don't recognize the command M503,  ok 0>>> M503SENDING:M503ok 0Unknown command:M503ok 0 trying the same in Repetier and same pproblem 15:16:46.341 : DebugLevel:615:16:46.3…

  in extruder is not increasing the distance according to the height of each layer Comment by frarce February 2022
• and sorry to bother you, maybe some of questions that I do sounds stupids, but I am not the normal profile for 3d printer enthusiast, I am a 52 years old narcotics police with 32 years in servise and sometimes tech stuff are hard for me, but I try t…

  in extruder is not increasing the distance according to the height of each layer Comment by frarce February 2022
• thanks for your fast answer, I did the test, down the z to 0 and up to 100mm, measured with the digital caliper and is perfect, I have 100mm in the caliper, the bed is calibrated too, I have a great addition of the first layer, I down the flow to 75…

  in extruder is not increasing the distance according to the height of each layer Comment by frarce February 2022
• sorry, I forget, my 3D printer is HE3D K280

  in extruder is not increasing the distance according to the height of each layer Comment by frarce February 2022