› ›

runekc

About

Username
runekc
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Well I went back to Windows 7 and it works perfect....go figure. I did compile the firmware myself. I will leave it as is for now, thank you so much for your help.
    in Connection issue Comment by runekc February 2022
  • Hi, deactivate/activate does also work....so is it a hardware issue with my new PC or perhaps Windows 10? This is the log when a connection is established: Mesg:10:26:26.952: Connection startedMesg:10:26:26.952: Printer reset requested falseMesg:10…
    in Connection issue Comment by runekc February 2022
  • LOW doesn't work HIGH does but the initial connection is still a problem, it only happens at boot...as I said all my settings are working after stop/start of Repetier-Server or if I unplug/plugin the 3D printer so something is missing at boot of Win…
    in Connection issue Comment by runekc February 2022
  • Hi, thanks but I can only set LOW, HIGH, LOW to HIGH or HIGH to LOW... Why wasn't that a problem with my Laptop?? all my settings are the same? This is what it says at first boot of the PC in the printer console: Mesg:16:03:46.008: Warning: Commun…
    in Connection issue Comment by runekc February 2022