fly_bye
About
- Username
- fly_bye
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
Rep. Thanks for the information it was a useful introduction to configuration.h which I did not have to use when the printer was new because the SD card contained a generic version of the settings. Now I know better. The printer is adjusted for bed …
-
Got you thanks. I was getting nervous because the steps/mm were getting so much bigger than X and Y.
-
Rep,I tested your suggestions with interesting results but the problem is not cured. The adjustment to Z_MAX_LENGTH did not seem to do anything but changes to ZAXIS_STEPS_PER_MM did. The adjustment required what seems to be fairly large changes so I…
-
Thanks Rep. I will be working on this in a couple of hours.