EdV

Comments

• I changed endstops to normal closed (read the manual!) and max homing. Everything works fine. Thanks for the info and this beautiful software Repetier. I am very happy with it! I swapped a few Marlin users over to Repetier  Thank you for the affor…

  in RADDS and DRV8825 Comment by EdV December 2017
• thnx I will check that!

  in RADDS and DRV8825 Comment by EdV November 2017
• Thank you for your comment

  in Configuration in Repetier Host Comment by EdV February 2016
• Ok thanks I'll check it out Ed

  in Do I use PRINTER_RADIUS in a wrong way? Comment by EdV December 2015
• HiYou could also consider to by the LCD unit for the RADDS, it has I cardreader built-in.

  in Due + RADDS external SD Comment by EdV December 2015
• It's working with Teensylu now, even connected the LCD.

  in Ramps endswitch doesnt work but now RADD also Comment by EdV December 2015
• ^:)^ I donated Regards Ed

  in Ramps endswitch doesnt work but now RADD also Comment by EdV December 2015
• Hmm i took for granted that it was the first 3 lines. Thanks for the reply!

  in Ramps endswitch doesnt work but now RADD also Comment by EdV December 2015
• Ok it's a delta.

  in Ramps endswitch doesnt work but now RADD also Comment by EdV December 2015
• Well in the proces of checking my endstop settings I lost one rampsboard due to replacing a broken  stepper driver in the wrong position. My wife saved me from throwing the printer out of the window. I replaced the RAMPS with a RADD and last night, …

  in Ramps does not see endstops, repetier however does Comment by EdV December 2015
• Thanks mate i'll check my settings Regards Ed

  in Ramps does not see endstops, repetier however does Comment by EdV October 2015
• Thanks, I'll check it out Ed

  in What switch for Z-levelling on Teensyluu board Comment by EdV May 2015
• Yep your right Y was configured as 100 max. Thanks!Ed ">

  in Steppers dont react on G code Comment by EdV April 2015