› ›

modiug

About

Username
modiug
Joined
Visits
0
Last Active
Roles
Member

Comments

  • Ok, reading the Duet documentation I found the solution, I need a G28 when switch on the printer, because "The tool change macro files are not run if the printer has not been homed since power up". Printing great now  Thank you GM 
    in Setup - Raise3D E2 idex Comment by modiug December 2021
  • Thank you for your answer. In my limited knowledge, I thought the g-code was simply passed from the control board to the motion board, but looks like there is a sort of translation to adapt the code to the printer. My idex printer has a Duet-like bo…
    in Setup - Raise3D E2 idex Comment by modiug December 2021