› ›

Xabbax

About

Username
Xabbax
Joined
Visits
100
Last Active
Roles
Member

Comments

  • Thank you very much !!!!!
    in G-code support Comment by Xabbax November 2014
  • Repetier thank you for this wonderful piece of software. May I request that you add the EEPROM settings for the extruder weightsto the Smart controller. That will allow one to make changes to the colours while printing not connected to a computer.Th…
    in Mixing Extruder Comment by Xabbax November 2014
  • Thank you !! Heaters now working and the mixing also working - Thank you for your hard work !!!!!!!
    in Mixing Extruder Comment by Xabbax November 2014
  • In http://www.repetier.com/firmware/v092/index.html-->Temperature -->selected Mixing Extruder (1 Nozzle/heater + 2 or more filament feeder)
    in Mixing Extruder Comment by Xabbax October 2014
  • Firmware v092 Repetier-Host v1.0.6Printer type DeltaPrinter settings 3 extrudersSelected: Printer has a Mixing extruder Scenario 5 (settings on Repetier - Host ) Only Extruder 1 bar visibleWhen I select heat extruder 1 - hotend will NOT heat upThe t…
    in Mixing Extruder Comment by Xabbax October 2014
  • Still having issues with heating.Firmware v091 Repetier-Host v1.0.6Printer type DeltaPrinter settings 3 extrudersSelected: Printer has a Mixing extruder Scenario 1 (settings on Repetier - Host) Only Extruder 1 bar visibleWhen I select heat extruder …
    in Mixing Extruder Comment by Xabbax October 2014
  • Thank you for the explanation of the virtual extruder algorithm. I still cannot get any temperature settings to function - tried to change the heater pins and the temp_pin settings settings to be the same in the pins.h file with no effect.I then tri…
    in Mixing Extruder Comment by Xabbax October 2014
  • 1.When I have 3 extruders and using 16 virtual extruders - what is the maximum weight for a virtual extruder 10, 30 or 100 2. Can one change the weight of the  virtual extruders while printing in Repetier_Host -->Config -->Firmware EEPROM conf…
    in Mixing Extruder Comment by Xabbax October 2014
  • PM me your address and I will send you a Tri-colour hotend (not mechanical mixer in it and also experimental)
    in Mixing Extruder Comment by Xabbax October 2014
  • Setting temperature over Repetier-Host does not work (v092)When I de-select mixing extruder in Repetier-Host there are 3 extruders but only the temperature of Extruder 3 corresponds to the temperature of the extruder on the smart controller. The ot…
    in Mixing Extruder Comment by Xabbax October 2014
  • Great!!!!! It is working - Thank You!!!!
    in Temperature changes with smart controller. Comment by Xabbax September 2014
  • It is not working - maybe something else to change or add as well.
    in Temperature changes with smart controller. Comment by Xabbax September 2014
  • Thank you!!!!!!
    in Temperature changes with smart controller. Comment by Xabbax September 2014
  • Thank you Repetier for clearing up the misunderstanding about the "Turn Extruder 1 off" I still have the problem of not being able to change the temperature of Extruder3The other two and the Bed temperature can be changed but not Extruder 3 Bed temp…
    in Temperature changes with smart controller. Comment by Xabbax September 2014