› ›

FireKnight

About

Username
FireKnight
Joined
Visits
2
Last Active
Roles
Member

Comments

  • OK found the Dashboard but unable to create a New Printer in the software, when I try to locate the configuration xml file there is none.
    in Initial configuration Comment by FireKnight April 2015
  • For ocinlaw: Hello, I am trying to get my k8200 to work, but I encounter a few problems at first, my heated bed at 837.25 degrees [little hot] but I can my xy and z axes not operate manually, I get 2 pin connector next to the reset button and I r…
    in Repetier-Firmware configuration tool Comment by FireKnight April 2015
  • I have my 3D Printer connected to the PC I installed Repetier Server on. I cannot configure the Server and unable to setup so I can use the Repetier Informer Software I purchased. Where is the Dashboard located? Thanks in advance for your help.
    in Initial configuration Comment by FireKnight April 2015