issacsim
About
- Username
- issacsim
- Joined
- Visits
- 11
- Last Active
- Roles
- Member
Comments
-
Works with the recommended sensor and settings, however I have an issue now when the sensor is triggered, both webcams go offline. I have to reboot the server to restore. How do I fix this?
-
Thank you.
-
Thanks ! "Work Better" is what I am looking for! What should be the GCode command used for the GPIO? Also, I ordered the BigTreeTech SFS 2.0, I see people using it on Pi 4 with Octoprint, so should be fine ?
-
Thanks, sounds complicated. I will start over again with SD card in the printer, the printer has resume built in. I will also start using a battery backup, we have a backup generator, so all I will need is few seconds on battery. Thanks.
-
Where is the rescue feature located? The print head is still at the last location of when power was lost, is there any way to query the printer for head location? Thank You!
-
Ended up getting the X-Plus and it works fine using the serial/USB connection. Only issue I am having is if you turn the printer off, it will not turn on while connected to the Serial/USB. Need to unplug the USB before pressing the power button to …
-
Any luck connecting this printer to Repetier Server? I really like it and would love to own one.
-
Sounds simple enough, I am a new user, was looking for it at the wrong place.
-
Thank you for the reply, Monitor says plug and play, no driver needed, I will check with the manufacturer.