› ›

percar

About

Username
percar
Joined
Visits
32
Last Active
Roles
Member

Comments

  • I have had similar issue. What it turned out to be was that the Decouple test period was too small and the controller thought that the thermistor had decoupled. What i did was to turn this up (it is defaulted at 1) to something very high i think 180…
    in Mid 3D Print Failure Need Help. Comment by percar January 2015
  • If you just send G32 S2 in the G code that is all you need to doYou do not need the rest of the code provided that you set it up when you set up the repetier firmware config.h
    in auto-bed leveling Comment by percar December 2014