pefozzy

Comments

• Thanks for the help. I checked the output voltage of the hot end, and it was fine. I took a look at the fan shroud and it seemed to direct most of it's output on to the hot end nozzle- so I redesigned it to direct more flow downwards. This seemed to…

  in Extruder temp decreasing then decoupled during long print Comment by pefozzy December 2016
• Anyone tried a fresh install of Repetier-Host to see if that solves the issue?

  in Repetier crashes after 2 minutes Comment by pefozzy April 2015
• I'm having the same issue- crashes soon after starting a print job.  Ubuntu 14.04RepetierHost 1.0.6

  in Repetier crashes after 2 minutes Comment by pefozzy April 2015