soroban925

About

Username
soroban925
Joined
Visits
3
Last Active
Roles
Member

Comments

  • In case it helps anyone in the future, the solution was that everything was backwards but my test shape was rectangular so X and Y being inverted still looked the same. I had my endstops wrong too, thinking X and Y were mins but they were actually m…
  • The line I am changing reads: G1 Z0.250 F7800.000 Which I am changing to : G1 Z199.750 F780.000 In order to be able to print that 1 layer. I am guessing that I need to make repetier think that Z home is 0 and to go from 0 - 200 as the bed goes…
  • Hmm. I home all axes before I begin. It starts at X=0, Y=0, and Z=200. The slicer is set up for .2mm resolution, and the first layer is a little bigger so it's starting Z height is .250mm. It also seems to completely ignore the speed on Z. It always…
  • Thank you very much for the help. It turns out it was working the whole time, it was just moving such a small amount that I couldn't tell, and it wasn't making any noise like the others did. Changing the steps per mm fixed everything.