marcomania
About
- Username
- marcomania
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
Danke!
-
i am using 1.1.0., and it happened again, the temperature report in the web interface was stuck at the starting temperature of the print. Sending M115 "repaired" it, the temperature is now reported again. I think it happens, when the printer was ina…
-
I had/have the same problem. After sending M115, the temperature is reported again. The output of the command: Recv:15:40:01.330: FIRMWARE_NAME:Prusa-Firmware 3.10.0 based on Marlin FIRMWARE_URL:https://github.com/prusa3d/Prusa-Firmware PROTOCOL_VE…