› ›

wkl666

About

Username
wkl666
Joined
Visits
22
Last Active
Roles
Member

Comments

  • Just fixed the problem by refresh the eeprom... maybe some corrupted data inside the eeprom caused the abnormal behaviour. Thanks Repetier
    in mixing extruder feedrate Comment by wkl666 March 2015
  • "I also assume that with NUM_EXTRUDER 2 extruder 1 stills behaves normally?" -> NO... once set NUM_EXTRUDER 2, both extruders including  extruder 1 have the same problem...really strange...
    in mixing extruder feedrate Comment by wkl666 March 2015
  • In my previous test, I set the mixing_extruder to 0 and num_extruder to 1 at the same time, then the problem gone. So, I guess the problem caused by mixing extruder settings, but I was wrong. In my last test, I set the mixing_extruder to 0 in config…
    in mixing extruder feedrate Comment by wkl666 March 2015
  • I just found that the problem not caused by the mixing_extruder enabled. It happened when I set the NUM_EXTRUDER to 2. 
    in mixing extruder feedrate Comment by wkl666 March 2015
  • Actually I really trying to run it without filament because I just want to test the extruders.If I set the MIXING_EXTRUDER to 0, the EXT0 can run as my expected speed, very fast extrusion/retraction. But if I set the  MIXING_EXTRUDER to 1, it always…
    in mixing extruder feedrate Comment by wkl666 March 2015