MagoKimbra
About
- Username
- MagoKimbra
- Joined
- Visits
- 92
- Last Active
- Roles
- Member
Comments
-
Please, Marco, MK4duo is not an evolution of Marlin2, the opposite.MK4duo has implemented the M530 M531 and M532 commands for many years and repetier host recognizes MK4duo and sends these commands to the firmware perfectly. Repetier Server should u…
-
Sure to have the right step for mm?With the new version also changed the eeprom then loads the values written in the firmware, you may not have the correct steps per mm and then moves double! See this line!!!08:07:14.629 : echo:EEPROM version mismat…
-
But the pre and post gcode not plugs directly Host? Or commands that are sent to Cura Engine and then Cura Engine that interprets them?
-
Oops ... I had not really seen ... sorry
-
This in Cura Software In Cura plugin i found only Infill overlap....
-
It Slic3r also supports more than 4 extruder, if you use all 4 are then used in the right order, but if you use 1 or 2 or 3 repetier always uses from 0 onwards. If I do it directly from SLic3r and then import the gcode used in repetier see the right…