› ›

jeffy_mathiuse

About

Username
jeffy_mathiuse
Joined
Visits
2
Last Active
Roles
Member

Comments

  • thank you, could you also tell me where i can get the latest repetier firmware without using the configurator tool, the one which has all the comments in the code 
    in help with setting endstops Comment by jeffy_mathiuse May 2021
  • Repetier said: You can move servo with M340 (see repetier.ino for gcode list). You can also define gcode scripts for deploy and undeploy servo which is where you would add the M340 commands to move the servo. Normally you should use the varia…
    in z probe with servo Comment by jeffy_mathiuse April 2021
  • Repetier said: d0/d1 are used by usb so hope that does not interfere. That is the default Serial port but you need to program the hc-05 with baud rate and to connect to your pc first. Too long ago I did that, but there is a helper software on…
    in bluetooth control using hc-05 Comment by jeffy_mathiuse April 2021