innovo3d

About

Username
innovo3d
Joined
Visits
14
Last Active
Roles
Member

Comments

  • Hi Deesun, I'm wondering if you've tried going back to Repetier for Auto Leveling.  I have a similar design for the Z-probe which also requires negative Z_PROBE_HEIGHT values.  I think if you follow the suggestions recommended above you will be able…
  • I having the same issue.  I am using a FSR (force sensor) attached to the extruder for the Z-Min Endstop and the Z-probe.  How should I have this configured for the Endstop and for the Z-probe?   I've tried Z-min as Switch on Ground, Normally open  …