Deluka
About
- Username
- Deluka
- Joined
- Visits
- 53
- Last Active
- Roles
- Member
Comments
-
When i disable the MIN_HARDWARE_ENDSTOP_Z i can get the nozzle closer but not when i enable it If I a but a negative value for the height only 1 point gets measured before printing starts.
-
:-*
-
oke found it just having a problem with the host under linux mint. I only can change 1 setting at a time, when i tried to change 2 at time the host crashes
-
Don't they change when you rewrite the firmeware
-
I only have this problem with extruder 2
-
Thx i installed the new version The second extruder heats up to the set tempatur but then starts to jump around. Going between 230 to 198 in less then a second and back in less then a second. With a older version of the firmware i have only the prob…