3dMistery

About

Username
3dMistery
Joined
Visits
48
Last Active
Roles
Member

Comments

  • So,zero response?
  • Sorry for late response, but I really don't have time to write about this topic anymore. Here are my settings,please check them and tell me if something is wrong:http://www.mediafire.com/download/pyj6zxumgsppvu6/Repetier-Firmware-2015-03-11.zip
  • Eeprom is enabled. AS I said (and I can wote it 50 more times)-I tested varoius settings-my own calculations, your recommendation adn even below you recommendation and Repetier FW is NOT working-but Marlin is. Why? I don't know.
  • Nothing is set wrong. As I said, Marlin is working fine with same settings. Repetier firmware is not working even with everything reduced. HW is working perfectly and all is tested. Every setting I did to Repetier FW was inside the configurator-eac…
  • It took me some time to get it sorted out, but it failed again. Only thing I got was uber slow movement.
  • I did it and it improved, but only a little bit. Should I put it 2? Also, what to input in Repetier host Travel feed Rate and Z-Axis Feed Rate? I think that also could be a problem.
  • I just tested Marlin firmware with Repetier host and everything is working fine with my settings. So, the error is in Repetier firmware.
  • As I mention I tried default settings for all axes, but I can't get decent moves unless I bump the speed and acceleration.X and Y are also driven by M8 rods.I tried numerous settings but nothing works. Does Repetier firmware have problems with DRV88…
  • Update:I tried to do something about this situation and results are weird.Using normal settings for M8 threaded rod (1/16, 2560 steps) I olaced jumpers on ramps and tied 1/81 1/4 and even half step. With half step I achieved 12 mm move for 50 mm com…
  • Eeeprom was enabled from start and setting were applied with each firmware flash. Lenght was set in firmware configurator, but I don't see that option in printer menu.Settings from last flash are there so that is right.I don't get that part with Z-i…
  • Thank you!