› ›

JojonetX

About

Username
JojonetX
Joined
Visits
0
Last Active
Roles
Member

Comments

  • The problem with the Z-axis speed when starting to print was that the axis goes down together with the extruder. It had a low speed set for printing 10 mm filament and therefore it also went slowly.
    in FW0.92 to FW 1.0.4 Comment by JojonetX August 16
  • Repetier said: The official position you can move to is defined by x_min, z_min. So setting them to -30 and -1 allows the move. If the position should not be officially allowed mit is possible because you moved 30mm right from endstop you can…
    in FW0.92 to FW 1.0.4 Comment by JojonetX August 16
  • I have one more question. Even though the Z-axis speed is set to 15 mm/s, it is terribly slow when starting to print. How do I adjust the speed?
    in FW0.92 to FW 1.0.4 Comment by JojonetX August 16
  • Thank you for the quick response.
    in FW0.92 to FW 1.0.4 Comment by JojonetX August 16
  • I solved the negative values. In the old version, it was enough to enter a value to shift the zero point in ENDSTOP_X_BACK_ON_HOME. The new version does not accept this and will not go into negative numbers. I solved it with X_MIN -30.
    in FW0.92 to FW 1.0.4 Comment by JojonetX August 16
  • Question number two.How to disable the display that I don't want.In my case I don't want the secondary displays when printing but I only want the home screen. Just like it was in the old FW version.
    in FW0.92 to FW 1.0.4 Comment by JojonetX August 16