GoBig
About
- Username
- GoBig
- Joined
- Visits
- 55
- Last Active
- Roles
- Member
Comments
-
I found out that I had an old version of OctoPi which used an older Python library. Switched to current OctoPi and everything works again.
-
I've updated to OctoPrint 1.3.6 recently too. It might have been that. Anyway, re-installing the Informer plug-in gives me the following error: /home/pi/oprint/local/lib/python2.7/site-packages/pip/_vendor/requests/packages/urllib3/util/ssl_.py:31…
-
Is there an "open bugs" list on 1.0.0 we can see to gauge how ready it is?
-
Can you tell me how to implement this for Z? I'm using 0.92.9 and the mirrored Z axis isn't showing up in the endstop section of the online firmware configuration tool. Was this implemented in the dev version or do I need to add code to the Config…
-
I found a configuration that works. For all others that want to do this configuration, here's what I did: 1. Assuming you have only min endstops, connect the Y endstop to the Y Max terminals on your control board. The rest are firmware changes.2. …
-
Can you add this for the X and Y axes as well? I have dual Y's and dual Z's. This is a very useful feature, especially for dual purpose 3D printers and mills.