rockyrude
About
- Username
- rockyrude
- Joined
- Visits
- 20
- Last Active
- Roles
- Member
Comments
-
Where would I find that? I didn't see it when I downloaded the firmware.
-
My problem was with the operating system. I upgraded to windows 8 and all my problems went away.
-
Also, running in compatibility mode doesn't help
-
I stand corrected, the window that opens says host has stopped working, and windows is looking for a solution. No solution found
-
My post about the python error was a mistake. When I try to start repetier host, a window opens saying windows is looking for a solution to a problem that is unspecified, it eventually fails with no explanation
-
The problem is that I can't get repetier to start
-
Sorry, this error is when I try to run cura 4.13.1. When I try to run repetier host windows just says the program has stopped running and is trying to find a solution which it doesn't
-
I get a window with a python errors
-
I am unable to download the windows documentation from repetier website
-
What version of cura is supplied? I am having issues with settings. Currently I am trying to adjust wall thickness.
-
I manually installed the .net framework 4.0 the installer demanded and the repetier host install seemed to complete. When I try to run the program I get a windows error trying to find a solution but fails.
-
I keep getting out of memory errors
-
Sorry, should have mentioned I am running a DaVinci 2.0 upgraded to repetier
-
My problem is that it does not self repair, just seems to go into an endless loop
-
I have uninstalled and reinstalled repetier host and solved the homing issue but I still can't over ride the temperature issue
-
I should have added that I am using a davinci 2.0 upgraded to repetier, it has been working well up to this point
-
Thanks, that did the trick. Now I just need to figure out how to offset the extruder to the correct position.
-
prusaslicer doesn't work with windows xp. No, I am not upgrading my OS
-
Sorry,had it backwards, extruder 1 is on the left, need it on the right
-
Yes, the firmware has extruder 1 on the right. I need it to be on the left.
-
I worded my question incorrectly, I am looking to reverse extruder 1 and 2.
-
I am running a version 1.3.0 from long before I thought of repetier. When I installed repetier host, is this the slicer host chose?
-
Can I just modify the value and compile/upload to my eeprom or do I need to clear the eeprom first?
-
Thank you
-
Is this setting in the configuration.h file? Do I set it to true?
-
I am seeing samples in the eeprom, I printed one and it IS one of the davinci sample prints
-
On a side note, I am having my trouble getting my davinci printer to accept z offset values. No matter what value I place, it always homes to the same position
-
Those were fine when I was using davinci firmware, now that I upgraded to repetier, I see sample files in the eeprom that I would like to know what they are before wasting time printing them.
-
My davinci doesn't use an sd card, the samples are in the eeprom
-
Not sure I understand how to do that