"Fan Pin" on Configuration Tool for 9.2

BruceInSD · September 2016

I have a Arduino Mega Ramps 1.4 board RepRapDiscount (Bigtree-tech.com)

I am using the 0.92 configuration tool

When i am on the "Features" page I select "fan pin" for cooling fan.

The problem is there is not obvious marking or connector for "Fan Pin" on the board

What connection is this routed to?

Repetier · September 2016

FAN_PIN is the middle output on RAMPS 1.4. If in doubt always enter the direct pin number from RAMPS pin schematics or check in pins.h which name maps to which pin.

BruceInSD · September 2016

Ok ... That's the pin I was using for the Hotend fan ..

Thanks

"Fan Pin" on Configuration Tool for 9.2

Comments