V1.0.6 - No Flowrate?
Just started running the new version. I see Feedrate is still there on the manual controls, but Flowrate is gone? I don't know about anyone else, but I found that feature to be extremely useful at times. Especially on larger prints where there is a significant amount of surface area to the first few layers. My printer would usually over-extrude on these, but I could compensate bu just changing the flow rate until the frist couple of layers were done.
Also, it seems the window at the bottom is gone. Unless I just can't find the tick box to turn it back on. This one isn't a big deal really, 99% of it's usefulness was just saying which layer it was on. But since that is over to the side, it's not a big deal.
Other than that, working great 
Comments