los steps after 17. Layer

Sorry for my bad english.
I have problem with my printer. To 16. Layer is print OK, but after 17. layers los steps in X axis. Printed shape turns to right side(from my eye) ca. 5 mm pro Layer.  My software is Repetier Host 1.0.6.
Help me please. 

Comments

  • Please always post in the right category. The informer app has nothing to do with this!

    It is normally not a host problem but a problem with firmware resp. firmware settings. Typical reasons are crosstalk to endstops, acceleration too high, speed to high, jerk too high, motor current not set right.
Sign In or Register to comment.