Units
Does Repetier recognise G20 and G21 commands?
I tried to view G-code generated with LineGrinder (which uses inches in G-code), and the scale of th emovements were too small.
I edited the G-code by changing G20 to G21 and reloaded the code, but the scale of the print preview didn't change.
Thanks and regards,
Bojan
I tried to view G-code generated with LineGrinder (which uses inches in G-code), and the scale of th emovements were too small.
I edited the G-code by changing G20 to G21 and reloaded the code, but the scale of the print preview didn't change.
Thanks and regards,
Bojan
Comments