With picture it is easer to say, but sounds like you have underextrusion so the computed width is not reached. Have you calibrated your extruder and the extrusion factor for your filament type?
Did you calibrate extruder correctly? This looks like under extrusion. Also make sure in host/server you have flow multiplier on 100% and not on 25%. First layer looks also like it did not stick very well, I guess also because there was not enough filament extruded.
The outer part is the ooze shield you have enabled. This is not part of your object and it is important it does not hit th eobject. That is totally correct. You use it for dual extruder printers where the unused extruder may drop plastic and it shields the object form getting these drops. For singe extruder prints it should be disabled.
Could you please give me a good set of settings to use. I'm going nuts trying to figure them out. The ones I have been using are above. I turned off the ooze setting. Now the outside edges are rough.
No I can't. Default is what I would give you but it depends on so many factors. Speed, temperature and extrusion multiplier are the most important here. But they also depend on your material, so no one can tell you what is best in your case if he does not use same printer and material.
Comments