Optionally show retractions in 3d preview (and Manual Control)
In the same way that it can be useful to see the travel moves, it can also be useful when tuning etc to see the points where retraction does (and does not) occur.
To do this, a new checkbox needs to be added to the preview tab, "Show retractions". The points where retractions occur should then be displayed, by a green (see below) vertical line, the length of which is the length of the retraction step.
Also, under preferences, Filament, a colour for retracts needs to be added.
To do this, a new checkbox needs to be added to the preview tab, "Show retractions". The points where retractions occur should then be displayed, by a green (see below) vertical line, the length of which is the length of the retraction step.
Also, under preferences, Filament, a colour for retracts needs to be added.
Comments