Step by step debuging

wnillissen · January 2018

Is there a way that I can debug changes I make to the Repetier firmware step by step?
I am using Slic3r on a Rumba board.
Wil Nillissen

Repetier · January 2018

You mean like a normal debugger on windows? It is more or less possible with a hardware debugger but it will always interfere with interrupts etc, so you can only set breakpoints and you normally can not see variables, only registers of cpu. So that is a pain. Easier is normally to add some Com::printFLN(PSTR("hgjgj"), value); to debug variables at special states.

guffy · January 2018

http://www.visualmicro.com/page/User-Guide.aspx?doc=Debugging-Explained.html

Step by step debuging

Comments