Homes very slowly then resets
Latest server Due board, 128x steppers, 640 steps per mm, G2 pullies. Trying to workout why it homes and moves very very slowly then cuts out and resets?
I have sped up the homing and movement speeds in firmware and Server setting but still sooo slow then resets its self. Are my steps too low? Why would it stop moving and reset?
I have sped up the homing and movement speeds in firmware and Server setting but still sooo slow then resets its self. Are my steps too low? Why would it stop moving and reset?
Comments
Also make sure endstops and bed are calibrated right so 0.2mm has a gap between bed and nozzle over the whole bed area. Especially if bed is tilted grinding on first layer can happen.