Using X, Y and Z motor drivers as extra motors
Setup without XYZ motors.
In a pick and place machine project I will use one board for XY and another without any XYZ motors.
The free motor drivers would be setup as extra motors for special actors.
However it seems that I can't do a setup without X, Y or Z motors configured.
Would it be ok to just dummy setup them as XYZ and also configure them as extra motors?
Or do I need to redirect the XYZ motor configuration to free dummy GPIO?
In a pick and place machine project I will use one board for XY and another without any XYZ motors.
The free motor drivers would be setup as extra motors for special actors.
However it seems that I can't do a setup without X, Y or Z motors configured.
Would it be ok to just dummy setup them as XYZ and also configure them as extra motors?
Or do I need to redirect the XYZ motor configuration to free dummy GPIO?
Comments