Reconnect before each print
Hello,
I'm very pleased with Repetier host v1.06 however I find that I need to disconnect and reconnect before starting a new print otherwise the hotend temperature doesn't register although it is heating. The first time this happened the hotend reached almost 300C before I realised what was going on.
Does anyone have any suggestions please? I'm using Marlin on Ramps 1.4 card and Kisslicer to slice.
Regards
Paul
I'm very pleased with Repetier host v1.06 however I find that I need to disconnect and reconnect before starting a new print otherwise the hotend temperature doesn't register although it is heating. The first time this happened the hotend reached almost 300C before I realised what was going on.
Does anyone have any suggestions please? I'm using Marlin on Ramps 1.4 card and Kisslicer to slice.
Regards
Paul
Comments