› ›

temperature curve , output bed

jappiejappie
in General
Hello 
I'm new to 3d printing, got a airwolf aw3d xl yesterday, under the Temperature curve Tab,  there are 2 graphs, output extruder and output bed, when I heat up both of them, nothing appears on the output bed graph, only on the extruder graph. both heat up.

Jean-Pierre

Comments

  • jappiejappie

    any suggestions ? Do you guys know from where the output power is taken from ?

     

    JP 

  • RepetierSupportRepetierSupport
    Output bed is taken from M105 response @B:255 for example. If the used firmware does not contain this you will see no output as the host does not know how much is used.
Sign In or Register to comment.